16mm 5A SPST Green Metal Push Button Switch 12V Momentary (Panel-Mount)

Upgrade your dash, control panel, or project box with a compact, durable metal push button switch thats simple to install and satisfying to press. This model features a momentary (non-latching) action and a bright Green 12V LED indicatorperfect for 12V automotive, marine, and DIY electronics.

Why Youll Like It

• Clean, modern look: Brushed metal body with a low-profile round actuator.
• Built to last: 304 stainless-steel housing with a robust PC light guide/button cap.
• Instant feedback: Integrated Green LED (12V) shows status at a glance.
• Quick install: Fits a standard 16mm panel hole with the included mounting nut.
• Great for 12V systems: Ideal starter, horn, accessory, or reset trigger in cars, trucks, UTVs, boats, and bench projects.
• INCLUDES Wired Socket:The included socket significantly decreases wiring complexity and increases electrical connection reliability. No soldering needed, no unreliable crimp terminals. Additionally makes swapping the button/switch a breeze!

  The 5 pin switch pigtail includes five pre-stripped wires:

  • Red: Positive pin for the LED lamp
  • Black: Negative pin for the LED lamp
  • Green: Common switch pin (C)
  • Blue: Normally Open (NO) switch pin
  • Yellow: Normally Closed (NC) switch pin
• Need additional sockets? Order more here!

What Momentary Means

Press to activate; release to turn off. Its the right choice for functions you only need while holding the buttonlike triggering a relay, resetting a device, or engaging an accessory temporarily.

Typical Uses

• Starter/ignition trigger (via relay) or accessory enable in 12V automotive builds
• Horn, lights, winch control (with appropriate driver/relay)
• Bench power/reset button for hobby electronics and control panels

Tech Specs

Whats in the Box

• 16mm Green 12V momentary metal push button switch
• Panel mounting hardware (locking nut)

Installation Notes

• Cut a 16mm hole, seat the switch, and secure with the included nut.
• Wire the LED to 12V DC (observe polarity) and route the switch contacts through your load or relay as requiGreen.
• For high-current devices (motors, starters, light bars), drive them via a relay or controller rather than directly through the switch.